Fastcorp, LLC
DIVI Setup and Users Guide
Page
16
of
62
Rev 6
12.
SHIPPING BRACKETS
.
The DIVI Vendor makes uses tie wraps to secure the robot arm during transportation. It is necessary to install
these tie wraps each time the machine is transported to or from location.
Freezer Lid Shipping Bracket Removal Instructions: The Freezer Lid Hold Down makes use of a red cable tie to
prevent the Freezer Lid from opening during shipping. The cable tie wraps around the Freezer Closed Switch
Actuator Plate and the Freezer Closed Switch Mounting Bracket on the right front of the Freezer. Carefully cut
the red cable tie and manually lift the freezer lid to make sure there are no obstructions.
13.
TURNING ON THE MACHINE
Note: Before turning on the machine, make sure the shipping brackets have been removed. The Robot
Arm should move freely in every direction and the Freezer Lid must open and close without restriction.
A.
Power Box
The rear main power box is the primary power source for the vendor. It is located on the inside cabinet wall behind or to the
side of the Freezer (depending on freezer model.) There is an ON/OFF Power Switch located on top of the power box that
supplies power to the freezer, and the power supply located to the left of the Product Delivery Bin on the bottom of the Front
Door. The Power Box has 1 input (power cord) and 2 outputs (freezer and power cord to the door power supply.) It also has
either (early machines) a fuse or 2 circuit breakers.
B.
Power Supply
The power supply is located to the left of the product delivery bin on the bottom of the Front Door. The power supply has an
ON/OFF switch located on the left side of the box which supplies power to the VMC, the robot arm, the digital display (if
equipped,) Currency/Telemetry systems, and the vacuum.
a)
To turn on the machine, first turn “ON” the power box switch behind the freezer. Then turn “ON” the door power
supply switch (left of the delivery bin on the bottom of the door). The Freezer and lamps will turn on, the Robot Arm
will present itself at the Delivery Position, the Display will light up, and the machine will be ready for Programming.
b)
Press the VAC button then scroll to Service Menu Option 13 to set the Health Timer so that the machine can be set
up before the Freezer cools down. See the Service Menu section for instructions.
SETUP INSTRUCTIONS
14.
Currency Systems
The DIVI Vendor supports only 24 - 34 volt Multi-Drop Bus (MDB) Money Systems
The DIVI Vendor is compatible with any MDB compliant, level 2 or higher coin mechanism or bill validator as well as most card readers
and telemetry systems.
Содержание DIVI
Страница 56: ...Fastcorp LLC DIVI Setup and Users Guide Page 56 of 62 Rev 6 Display Assembly Freezer Lid Closed Switch...
Страница 61: ...Fastcorp LLC DIVI Setup and Users Guide Page 61 of 62 Rev 6...
Страница 62: ...Fastcorp LLC DIVI Setup and Users Guide Page 62 of 62 Rev 6 VMC Connector layout...
