Basic Training Workbook
Version 1.5 - August 2007
37
Chapter 3: Feature Measurements (Metrology Mode)
Cone
Use the Cone command to measure a cone on your part. The cone measurement best-fits a
face through digitized points.
4
Type a name for your measured cone, or use the default name.
•
If this cone is a datum of your part, select the DATUM check box.
5
Select OK to measure the cone.
6
Measure the cone with the FARO Gage.
•
Place the ball probe on the part and digitize points with the GREEN button.
1
Select the FEATURES drawer
in the Toolbox.
2
Select the Cone command.
3
Select the RUN button.
