Basic Training Workbook
Version 1.5 - August 2007
36
Chapter 3: Feature Measurements (Metrology Mode)
7
Measure the center hole with the FARO Gage.
•
Place the ball probe on the part and digitize points with the GREEN button.
•
Digitize 3 or more points in the hole.
•
Pull away from the hole edge and digitize 1 point with the RED button to complete
the command.
8
View the results of your measurement in the R
ESULTS
dialog box.
9
Type Nominal diameter =
100
and Tolerance =
+0.25, -0.10
.
10 Select OK to add the hole to your FARO Gage part file.
11 When prompted to measure the next hole, select CANCEL.
