Manual
KOMPAKTOMAT K1250PS | K1570PS
8
│
46
J.2
(xx)
It is recommended to store the machine in the transport position, i.e. the side frames folded and
secured by the connecting rod and the machine resting on the supporting leg. The operator must secure
the stored machine from spontaneous movement by activating the hand brake of the machine.
J.3
(3)
The operator is obliged to secure the storage place against unauthorized persons' entrance.
K.
MACHINE REPAIRS
K.1
(1)
Servicing and maintaining the machine can only be carried out by qualified persons duly authorized by
the operator, see Chapter A.4.
K.2
(2)
Any machine repairs may only be made at rest, i.e. the machine does not work. If it is necessary for
the machine to be coupled with the tractor during the repair, the ignition key must be removed from
the switchbox.
K.3
(5)
All kinds of the machine hydraulic circuit repairs may only be made under the following conditions:
(6)
The lateral frames are unfolded,
(7)
The machine must rest on the shares and rollers;
(8)
The machine must be secured against undesirable motion;
(9)
The machine hydraulic circuit must be disconnected from the tractor hydraulic circuit;
(10)
The machine vicinity must be protected from being contaminated by hydraulic oil;
(11)
The machine must not rest on the axle.
K.4
(3)
Any machine repairs should be made in service shops.
K.5
(12)
Before repairing the machine hydraulic circuits, the repairman must eliminate pressure in the
hydraulic circuits with the control levers in the tractor cab. This should be done by moving the levers to
their extreme positions back and forth (approx. five times) with the tractor engine stopped.
K.6
(4)
When handling the machine with a lifting device, the regulations set forth in Chapter C should be
strictly observed.
L.
REPLACEMENT OF WORN-AND-TORN SHARES
L.1
(xx)
The operator or the serviceman must observe generally valid safety regulations during any
replacement of working bodies.
L.2
(1)
The shares should be replaced by the serviceman or operator on a flat and paved surface only.
L.3
(2)
When replacing the shares, the machine must be aggregated with the tractor according to Chapter E.
When replacing the shares, the tractor engine must be stopped and the tractor cab secured against
unauthorized entrance or operation.
L.3
(5)
If there is a leakage from the tractor hydraulic system, the repairing person is obliged to support the
machine shaft mechanically.
M.
MACHINE DISPOSAL AFTER ITS SERVICE LIFE
M.1
(xx)
The owner shall observe generally valid safety regulations in case of any disposal.
M.2
(1)
The operator must ensure that the machine is secured against undesirable motion before starting the
disposal operations.
M.3
(2)
The operator must ensure that metal parts are separated from those parts that contain hydraulic oil
or grease.
