Manual
KOMPAKTOMAT K1250PS | K1570PS
7
│
46
G.5
(7)
Note that the driving properties of the set change when towed by a tractor on the road due to
different axle loads. Please have this in mind when transporting the machine. The respective road-
transport rules should be strictly observed.
G.6
(8)
The operator is obliged to produce the respective certificate of roadworthiness (the MOT Certificate)
if necessary.
G.7
(9)
When transporting the machine on public roads, all the respective traffic rules and traffic signs should
be observed.
G.8
(10)
When making U-turns or driving reverse gear, be especially careful. Ensure a good outlook from the
tractor cab and use another (instructed and authorized) person if necessary.
G.9
(11)
When transporting the machine off public roads, operator(s) should not exceed the lowest maximum
transport speed and the lowest maximum slope accessibility indicated wherever on the set.
G.10
(xx)
The operator must secure the folded side frames by the connecting rod to prevent their unfolding
before the start of transportation on ground communications.
H.
OPERATING THE MACHINE IN THE FIELD
H.1
(1)
The operator should acquaint himself with the machine controls before the first use of the machine.
H.2
(2)
Before setting the machine to work, please read the Instructions for use carefully. Pay attention to
labour protection, safe operation and transportation, environmental protection, setting the machine
and its maintenance.
H.3
(3)
The operator is responsible for all damages incurred by improper operation of the tractor and the
coupled machine.
H.4
(4)
When operating the machine, the operator is obliged to observe all the technical and safety regulation
set by the manufacturer.
H.5
(6)
When operating the machine, the operator should observe the prescribed working depths and speeds
given in Chapter 2/Page 16 of this manual.
H.6
(7)
When leaving the tractor cab, the operator is obliged to lower the machine onto the ground and
secure it against undesirable motion.
I.
MACHINE ADJUSTMENT
I.1
(1)
When adjusting the working tools of the machine, the operator should follow the values
recommended in Chapter 9/Pages 27 to 34. Please observe the labour safety principles.
I.2
(2)
The machine working tools may be adjusted at rest only with the machine secured against undesirable
motion.
I.3
(3)
Working tools adjustments should be done on a flat and paved surface so that the soil cultivation is
performed evenly.
J.
STORAGE
J.1
(1)
Before storing the machine, the machine should be thoroughly cleaned and preserved in such a
manner that no damage can occur. Special attention should be paid to all the lubrication points
indicated. These points should be lubricated thoroughly according to the Lubrication Chart, see Chapter
14./Page 43.
