ATTENTION!
Do not make yourself any change in the device. It may cause
damage to equipment or improper work, which can lead to
damage of the controlled device, and the risks for people
handling. In such cases, the manufacturer is not liable for any
event and may refuse the warranty given to the relay in case of
filing a complaint.
Set ZERO
This menu is use to reset value of total meter.
Pressing the OK button will reset reports of total meter to without
any additional enter.
00000000
TOTAL:
Set ZERO
MENU
OK
LANGUAGE
This menu make possiblity to choose language in wich will
display information .You can choose polish, english, russian
language.
OK
RESET
p
q
MENU
LNAGUAGE
LNAGUAGE
LNAGUAGE
LNAGUAGE
Polish
English
English
Polish
Saved
Saved
OK
To change the language, select the menu language and press
OK. Then, using the UP and DOWN buttons to select the
language. Enter by OK. Confirmation of changes is displayed in a
new language set, which is shown in the above picture. To exit the
menu without saving changes is possible by press the RESET
button.
Filtr
NO
Filtr
2Hz
Filtr
5Hz
SAVED
xxxxHz
Filtr
500Hz
Filtr
1000Hz
RESET
p
q
FiltrDC
MENU
OK
OK
After you select a menu FiltrDC press OK. Then, using the UP
and DOWN buttons to select the appropriate frequency filtering
and approve it OK. Exit menu without saving changes is possible
by pressing the RESET button. Set the menu item in FiltrDC
doesn’t mean exclusion of the internal filter. FiltrDC doesn’t work
if you set the meter to the signal AC_50 Hz.
WIRING DIAGRAM
supply
24÷264V AC/DC
INPUT: voltage - low status
0÷5VAC/DC
voltage - high status
10÷264VAC/DC
frequency for signal DC
<5kHz
frequency for signal AC
<50Hz
RESET: voltage
24÷264V AC/DC
current load of joint 1P
8A
power consumption
1,5W
working temperature
-20÷50°C
connection
screw terminals 2,5mm²˛
dimensions
3 modules (52,5mm)
fixing
on rail TH-35
TECHNICAL DATA
8
4
3
RESET
INPUT
-/~
-/~
AC/DC
1
2
11
12
7
10
+/~
+/~
1. Take OFF the power switchgearbox in which the device is
attached. 2. Put the device to the rail.
3. Connect the power cables to joints 1 and 2.
4.Connect other cables with wiring diagram. Please note that in
the cause of work with DC signals, it is important to preserve the
appropriate polarity.
ASSEMBLY
A090729
