PURPOSE
Pulse meter is intended for counting AC/DC voltage signals,
generated by additional peripheral devices in order to determine
the number of carried out working cycles in automatics systems,
e.g. in order to control the number of press strokes, the number of
revolutions of a rotating device, the number of components
leaving the production line, etc.
CLI-01
CLI-01
www.fif.com.pl
ul. Konstantynowska 79/81
tel/fax 48 42 2270971 POLAND
e-mail: [email protected]
95-200 Pabianice
F&F products are covered by an 24 months warranty from date of purchase
PULSE METER
METER FUNCTIONS
- control panel, enabling programming and the monitoring of
device operation
- T input, adapted for operation with AC/DC signal, 5 to 264V
amplitude and 50 Hz frequency for AC and 5kHz for DC signals
- possibility to set THRESHOLD parameter (1÷99 999 999
range), specifying the limiting number of pulses counted in a
single operation cycle
- external RESET input
- relay output signaling the preset meter state (contact1C/O 8A)
- local counter, reset using the external reset input or using
RESET button
- total counter for all impulses (loop mode 0
→
99 999 999
→
0
→
...
or reset using the meter configuration menu)
- digital filter, enabling the limiting of maximum frequency of the
counted pulses (in order to reduce interferences on meter input)
- local and total meter state memory after supply failure
- program menu in three languages: Polish, English or Russian
5 9 0 8 3 1 2
5 9 1 7 6 4
Description of display and control panel
The services and programming meter CLI-01 is used mounted on the
casing front panel control. It consists of a two lines, eight alphanumeric
display, and placed under it keyboard with five buttons.
01304569
TOTAL:
Two lineseight
alphanumeric display
Control
buttons
CLI-01
RESET
OK
MENU
p q
Display present information about the current state of work, and in
programming mode allows the configuration of the meter
parameters. The buttons on the control panel, perform the following
functions:
MENU
Button functions:
MENU
- pass to programming mode. In the cause that the meter
is working in the editing parameter mode, of a number, press this
button to go to the next edition of the digits.
FUNCTIONING
Meter CLI-01 is a one-way meter which count to up. Pulses are
counted from zero to a value set by the user.
RESET
p
q
UP and DOWN - to select the next position of menu, and to
increase or decrease value of editing parameter.
OK
-
pass to choosen position of menu and to enter changes
RESET
- resetting to the current meter cycle. In
programming mode allows return to main menu If the
RESET button is pressed while editing a parameter, it go out
from edit mode without saving changes.
OK
SET VALUE
M
A
T
E
R
3sec
P
U
L
S
E
S
R
E
S
E
T
J
O
IN
T
ON.
Device status is indicated by messages on the display. During the
counting of pulses on the display, see the following information:
00000999
>>
Status of transformer
output
(open joint)
Signalization
read of pulses
Actual
reports of meter
Signalization
work of meter
The achievement of the set value is indicated by closure of relay
joints. At the same time stops counting pulses, the illumination of
display blinking three times, and the display shows the message
STOP.
00002000
STOP
Actual and set
value of meter
Signalizaton achievement
of the set value
Status of transformer
output
(open joint)
