Falcon RJ-8000, Руководство пользователя, Страница: 156 / 190

6 Troubleshooting RJ-8000 OPERATION MANUAL
6-6
(14) Media size is wrong during media Initial.
(15) Media is fed crooked while printing.
(16) The printer is not connected to a computer using the Centronics interface.
(17) The printed lines are blurry.
No. Possible cause Solutions References
1 You did not use recommended media. Use recommended media.
4.3.1 Media type
2 You did not load the media straight into the
printer. Load the media straight into the printer.
3.6 Media
handling
3 The curled surface of media is up when
loading. Remove the curl in the media, or replace with
new media.
3.6 Media
handling
4 You used the printer where air from an air
conditioner blows or other location not
appropriate for the specified environment Use the printer in the specified environment.
7.2 Product
Specifications
5 You reused printed media. Use new, not printed media.
4.3.1 Media type
No. Possible cause Solutions References
1 You did not use recommended media. Use recommended media.
4.3.1 Media type
2 The loading position of the media is not
correct. Load the media correctly.
3.6.2 Loading
roll media
3.6.3 Loading
sheet media
3 The stroller is not set correctly. Set the stroller correctly.
3.6.1 Attaching
roll media
No. Possible cause Solutions References
1 You did not connect the Centronics interface
cable correctly. Connect the Centronics interface cable
correctly.
3.8.3 Connecting
the centronics
interface
2 When the printing data is transferred from the
computer, the DATA lamp on the operation
panel is not lit. If the DATA lamp is not lit, contact the
computer maker. -
3 The Centronics setting on the printer does not
match the setting on the computer. Make the Centronics setting on the printer so
that it matches the setting on the computer.
3.8.1 System
requirements
4 The type of command that is currently set does
not match the command of a computer or a
driver. Match the command setting of the printerto
the environment of a computer or a driver.
4.4.2Items in the
setup menu
No. Possible cause Solutions References
1 You did not use recommended media. Use recommended media.
4.3.1 Media type
2 You used too thick or thin media. Use recommended media.
4.3.1 Media type
3 You used bond media. Use recommended media.
4.3.1 Media type