____________________________________________________________________________
- 31 -
4. Set “Length”, press
to validate it, the editing cursor will move to “Cycle” automatically;
5. Set “Cycle”, press
to validate it, the editing cursor will move to “Link” automatically;
6. Set “Link”, press
to validate it, the editing cursor will move to “SEQ Step” automatically;
7. Set “SEQ Step”, press
to validate it, the editing cursor will move to “V_Set” automatically;
8. Set “V_Set”, press
to validate it, the editing cursor will move to “I_Set” automatically;
9. Set “I_Set”, press
to validate it, the editing cursor will move to “SEQ-Delay” automatically;
10. Set “SEQ-Delay”, press
to validate it, the editing cursor will move to “SEQ step” and increase its value
by 1 automatically;
11. Repeat procedures of 7 ~ 10, till all sequence steps have been programmed.
12. Press
to save the programmed sequence file.
13. Press
to quit sequence editing.
-----------------------------------------------------------------------------------------------------------------------
When power supply output is ON, sequence editing is not allowed
.
-----------------------------------------------------------------------------------------------------------------------
Running sequence file
1. Press
to enter into test function select,
2.
Rotate the rotary knob to select “SEQ”, press
to call sequence test function, screen display as below
Figure 3-18 Sequence Test Display
3. Press
to edit “Run file”, rotate the rotary knob or press number key to input sequence file number;
