40i TS - v1205 - Installation/Operation - (26/29)
4 Appendix
4.1
UL seal
See page 13
.
4.2
CE seal
Warning
Before starting up the DRO, carefully read the instructions of Chapter 2 in the
Installation Manual.
The DRO must not be powered-on until verifying that the machine complies with the "89/
392/CEE" Directive.
4.2.1
Declaration of conformity
Manufacturer:Fagor Automation, S. Coop.
Barrio de San Andrés 19,
20500, Mondragón -Guipúzcoa- (SPAIN)
We hereby declare, under our responsibility that the product this manual refers to
Note. Some additional characters may follow the references to the models indicated in this manual.
All of them comply with the following regulations:
4.2.1.1
Electromagnetic compatibility:
EN 61000-6-2:2005 Standard on immunity in industrial environments
EN 61000-6-4:2007 Standard on emission in industrial environments
According to the European Directive: 2004/108/CE on electromagnetic compatibility.
In Mondragón, September 1st, 2009
4.2.2
Safety conditions
Read the following safety measures in order to prevent damage to personnel, to this product and to
those products connected to it.
Fagor Automation shall not be held responsible for any physical or material damage derived from the
violation of these basic safety regulations.
Do not manipulate the inside of the unit
Only personnel authorized by Fagor Automation may open this unit.
Do not handle the connectors while the unit is under power.
Before handling the connectors (mains, feedback, etc.) make sure that the unit is not under power.
Use proper Mains AC power cables.
To avoid risks, use only the Mains AC cables recommended for this unit.
Avoid electrical overloads
In order to avoid electrical discharges and fire hazards, do not apply electrical voltage outside the
range indicated in chapter 2 of this manual
