40i TS - v1205 - Installation/Operation - (17/29)
3.5.3
Power and machine connection
Always mount it vertically so its keyboard is within operator's reach and its digits are easily visible (at
operator's eye level).
Do not connect or disconnect the DRO connectors while it is under power.
Connect all metallic parts to a common point on the machine tool and it to the general ground point.
Use cables of enough gage (no thinner than 8 mm
2
) for this connection.
3.6
Installation parameters
3.6.1
Accessing installation parameters
Gives access to setting installation and user parameters
and to the test mode.
The parameter setup is divided into three parts:
1- USER PARAMETERS: Parameters that may be
modified by the user: change the language, set the clock
and set the screen color.
2- INSTALLER PARAMETERS: Parameters that must be
set when installing the DRO for the first time, when
replacing an encoder or when doing a repair. They are
parameters related to the machine, feedback and to the
DRO itself.
3- TEST MODE: To check the various status of different elements of the DRO, such as screen,
keyboard, etc.
For the installer only. Accessing the test mode requires a password:
Password:
231202
3.6.2
User parameters:
Parameters that may be modified by the user: change the language, set the clock and set the screen
color.
3.6.2.1
Language
Use the cursor keys to select the language.
Press Enter.
Home search
Setup
Setup
Test
Installer
User
Color
Language
Password
231202
DRO
(type, axes, alarms)
Feedback
(encoders)
Compensation
(linear, multi-point)
Machine Control
Setup
Setup
User
Install
Test
Setup
Setup
User
