40i TS - v1205 - Installation/Operation - (6/29)
2.2
Set/Clear
There are two ways (modes) to set a value (Set) on the display or zero it (Clear).
2.2.1
In " Set" mode (indicated with an " S" on the upper status bar)
To preset a value for an axis.
To zero the axis, either preset a 0 value using the previous
keystroke sequence or use this other sequence (clear +
axis).
2.2.2
In " Clear" mode (indicated with a " C" on the upper status bar)
Set the display to zero.
To preset a value:
And validate the data by pressing this key.
Or ignore it by pressing this key.
2.3
Machine reference (home) search
Select axis. A red bar appears on that axis display
indicating that it is waiting for a reference pulse.
Move the selected axis until the DRO detects the
reference mark.
A green checkmark appears next to the axis display when
the reference mark is properly detected (homed) and the
axis display will show the position value preset in
parameter "user offset", (see
" Reference" on page 21
).
2.4
Tool:
Each tool will remember the RPM and CSS values
programmed by the user.
When the tool number is changed, the saved values will
be set as current. If the spindle is turning , it will stop
before setting the new values.
Display
Set/Clear
Value
Value
Setup
Home search
