40i TS - v1205 - Installation/Operation - (10/29)
2.6.1
Set RPM
For setting the RPM value for the current tool.
RPM: Desired value in revolutions per minute
Range: Gear range position
Validate the programmed values
Exit without changing values
Note:
The preset value must be between the minimum and the maximum rpm for the selected range (gear).
Setting the RPM value turns the CSS mode OFF.
2.6.2
Set Constant Surface Speed, CSS
For setting the Constant Surface Speed value for the
current tool.
CSS: Constant surface speed in m/min or ft/min.
Max RPM: Maximum working RPM value
Range:Gear range position
Disable the CSS mode
Validate the programmed values
Exit without changing values
Note:
When CSS mode is ON, the CSS display of the main window will show a yellow light.
If the X axis value is changed by clearing it or by presetting a new value, the spindle will stop for
safety.
2.6.3
Angle measurement.
It may be used to calculate the angle or taper of a part by
touching two points.
Touch the first point and press Enter.
Touch the second point and press Enter.
It shows the calculated angle in degrees and degrees -
minutes - seconds.
Function
RPM
Function
CSS
Function
Angle measurement
