40i TS - v1205 - Installation/Operation - (23/29)
3.6.5.1
Spindle Configuration
For setting the values for spindle control.
Spindle encoder. Defines whether the machine has an
encoder connected to the spindle or not.
Spindle control: When selecting closed loop, the DRO
will try to follow the programmed rpm.
Acceleration time: Time required by the analog signal to
go from 0V to 10V. It is limited to 7 seconds.
Analog output: Depending on the drive, unipolar from 0V
to 10V or bipolar from -10V to +10V.
M3 value: Analog command value for M3 rotation.
RPM inc: The value for RPM UP and DOWN keys.
External JOG only: Disables the M3 and M4 keys of the DRO, the external JOG can only be used to
start the spindle.
3.6.5.2
Spindle orientation
In order to be able to stop the spindle in a particular
position, the system must have an encoder mounted on
the spindle.
Spindle orientation: It turns that option on or off
RPM: RPM during spindle orientation.
Distance: Angular anticipation distance to stop the
spindle.
Setup
Setup
Machine Control
Setup Spindle
Installer parameters
Setup
Setup
Machine Control
Setup Spindle
Installer parameters
Stop
RPM
Stop in open loop
Stop position
Analog command
Distance
