Fabdec DARI-KOOL GALA-KOOL Pro, Инструкция по установке и эксплуатации

Страница: 44 / 92

Page 44
Working level
for normal daily operation
Temperature settings Range Default
c1 Target temperature for T1 -2,0 .. 12,0°C 4,0
c2 Target temperature for T2 -2,0 .. 12,0°C 4,0
The target temperature is the temperature to
which the milk is to be cooled down. When the
target temperature is reached the compressor
switches off. See diagram.
c10 Hysteresis for target temperature 1 0,1 .. 2,0 K 0,7
c11 Hysteresis for target temperature 2 0,1 .. 2,0 K 0,7
The hysteresis determines the amount by which
the milk temperature is allowed to differ from target
temperature T1 or T2 before the cooling compressor
is switched on again. See diagram.
Agitator running time settings Range Default
c20 Duration of after-stirring 0 .. 999 sec. 120
Period in seconds for which the agitator continues
to operate after the compressor is switched off.
c21 Pause duration 0 .. 999 min. 20
Period in minutes between agitator switching
off and switching on again (for the duration
of the after-stirring period selected).
c Duration of 'intermediate stirring SHORT' 23 0 .. 999 min. 2
Period in minutes during which the agitator
operates if the UP arrow button is pressed
for
during a cooling pause. approx. 1 second
c Duration of 'intermediate stirring ' 24 LONG 0 .. 999 min. 10
Period in minutes during which the agitator
operates if the UP arrow button is pressed
during a cooling pause. for approx. 3 seconds
8.2 Level “General cooling parameters” (c parameters)
Switch to level
“General cooling parameters”
See section 8.1.
c parameters
Code: C212
0°
T2
T1
Hysteresis
for T1
Target-
temperature
Hysteresis
for T2
Target-
temperature
General cooling parameters code: C212
Extended cooling parameters code: D345
General cleaning parameters code: B454
Extended cleaning parameters code: C567
Service parameter s code: EA03
General tank monitor parameters code: 4711
Extended tank monitor parameters code: F94A
Alarm configuration code: FFFF
Configuration code: A384
I/O test parameters code: 10E5
8. Setting of parameters