Fabdec DARI-KOOL GALA-KOOL Pro, Инструкция по установке и эксплуатации

Страница: 15 / 92

if parameter [c25] = '0'
Press the “AGITATOR” button: (from OFF mode)
Switches on continuous stirring mode (revolving bar in the display).
Press “OFF” button:
Switches off continuous stirring mode.
if parameter [c25] '0' >
Press the “AGITATOR” button: (from OFF mode)
If parameter [c25] is set higher than '0', when the button is pressed the agitator
runs for the set number of minutes.
Press “OFF” button:
Switches off continuous stirring mode prematurely.
The “Agitator” LED lights up
The “Compressor” LED lights up only when the compressor is actually running.
- it is not lit if the milk temperature is lower than the target value
- . it flashes for the duration of the min pause time for the compressor [P71]
The “T1” or “T2” LED (for target temperature 1 or 2) lights up.
The pre-set
target temperature T1 or T2 flashes three times in the display, then
the current temperature of the milk is shown.
If you wish to change to the other target temperature: press the COOL button
again. (Switching over from T1 to T2 may be blocked via parameter [P80]).
The milk is now cooled down to the set target temperature, and the agitator runs
continuously during cooling. If the milk temperature is already below the target,
just the agitator runs for the time being.
When the target temperature is reached, the compressor switches off.
At the end of the set “after-stirring” period [c20], the agitator also switches off.
During cooling breaks the agitator switches on periodically, in line with the set
“pause time” [c21] for the “after-stirring” period [c20], in order to ensure an
even temperature throughout the milk.
If the milk temperature rises again, and exceeds the selected target tempera-
ture by the hysteresis value [c10 or c11], the compressor and agitator are
switched on again automatically.
Continuous stirring mode
Stirring in cooling mode = INTERMEDIATE STIRRING
(only if released in parameter [P22])
In cooling mode, briefly press the AGITATOR button:
A “short intermediate stirring” is triggered [duration = c23].
The indication “Sho” is displayed.
In cooling mode, press the AGITATOR button for 5 seconds:
A “long intermediate stirring” is triggered [duration = c24].
The indication “Lon” is displayed.
5. Operation
T1
T2
Page 15