F.W. Bell 8000 series, Инструкция по эксплуатации

Страница: 43 / 132

F.W. BELL 8000 Series Gauss/Tesla Meter Instruction Manual
Section 5 – User Interface 5-6
Display System
Information
Information about the meter and probes connected to the meter including the
firmware revisions, model numbers, serial numbers, calibration dates and
other miscellaneous data can be viewed using this menu selection.
To View System Information:
1) From the MAIN menu, navigate to the SYSTEM menu and select the
“Display System Info” hot key button.
2) Press the menu button to exit this screen.
User Setup
Save and
Recall
Up to 10 user setup configurations may be saved in the meter’s internal flash
memory. These setups are saved in non-volatile memory and may be
recalled at anytime, including after a power on/off cycle. The settings from all
menus are saved including those enabled remotely or from the front panel.
To Save or Recall a Configuration Setup:
1) From the MAIN menu, navigate to the SYSTEM menu and select
“User Setup Save-Recall”.
2) Use the number entry hot keys to enter the desired setup profile (1 to
10).
3) Select either “Save” to save the current setup to memory or “Recall”
to load a setup from memory.
4) Press the MENU button to exit the User Setup Save and Recall
menu.
To Load Default Settings
:
1) From the main menu, navigate to the SYSTEM menu and select
“User Setup Save-Recall”.
2) Press the “Default” hot key button to load the default system settings
as shown in Table 5-2.