- 15 -
Maintenance
・
check-up
７
7-1 Cleaning and caring the product
Warning
Caution
(1) Make sure that the RUN lamp is off.
(2) Make sure the liquid temperature has sufficiently
cooled down, turn the power switch OFF and
remove the power plug out of the outlet.
(3) Drain the liquid in the bath.
(4) Use a tightly wrung off soft cloth for cleaning.
Use mild detergent for stubborn dirt and completely
remove any remaining detergent.
Do not clean and care the product
while it is still hot.
Cleaning and caring the product while it is
still hot may burn yourself.
Caution
Caution
Use appropriate product for cleaning
and caring the unit in proper way.
When cleaning and caring the product, do not
pour water directly on the external and internal
portion, and also do not use cleanser, thinner,
petrol, lamp oil, acid and related products.
These products may cause electric shock or
damage the unit.
Remove the scale on the bath
immediately
Continuing use with a stone may cause overheat of
the bath bottom and damage the product.
Caution
Do not scratch the bath.
Inner surface of the bath is Teflon coated for being
cleaned efficiently.
Scratching the inner surface may damage the
product.
Never attempt to disassemble the
product.
The unit contains parts with high voltage applied or
may become hot, and disassembly may cause an
electrical shock or an injury.
7-2 Replacing the fuse
(1) Turn the power switch OFF and pull out the power
cord from inlet with fuse.
(2) Use a small flat-head screwdriver or the like to remove
the fuseholder.
(3) Replace the 2 fuses with new ones at the same time.
(4) After replacement, push the fuseholder to the end.
※
When the inlet fuse is blown while the unit is in
operation, take care for burning or a no-liquid
heating because the heater will automatically turn
on (power outage recovery mode) at powering on
if the temperature in the bath is below the set
temperature for checking the display.
※
Only use a fuse with the same standard and
the capacity as the old one.
Pull out this part
Time-delay
Type fuse
(8A)
Inlet with fuse
Fuseholder
Specification
Capacity
Slow blow type
, φ5.2×20
T8A
①
②
