EYELA SB-1300, Инструкция по эксплуатации

Страница: 13 / 22

- 9 -
Set
Run
Stop
▼
▲
℃
Run
Heating
Set
Run
Stop
▼
▲
℃
Run
Heating
Set
Run
Stop
▼
▲
℃
Run
Heating
Set
Run
Stop
▼
▲
℃
Run
Heating
5-2 Operating procedures
Stop using the product if you find
any trouble.
When you face the trouble, turn off the power switch
immediately and refer to
“
6.Troubleshooting”on
page14
Do not touch the hot part during
use and for a while after use.
Bath and flask for specimen are in hot temperature
during use and for a while after use. Touching these
parts may burn yourself.
Completely allow the inside of the unit to dry after using water of a
temperature below the room temperature.
Use the unit under the environment below when you are going to use the unit with cool water (5
℃
or higher)
below the room temperature.
Completely allow the inside of the unit to dry after using cool water.
※
When cool water is used, condensation water may drip from inside the unit onto the experiment table.
<Use environment> Room temperature
：
20
℃±
5
℃
; humidity
：
60% or less
Caution Caution
Caution
※
Make sure that a correct amount of water is in the bath.
(1) Turn the power switch ON.
The whole display comes on, indicates the model [ Sb], the mode
switches to the measurement mode and displays the present liquid
temperature.
(Temperature indication on)
(2) Pressing the SET key switches to the setting input mode.
(Temperature indication flashes)
※
The temperature is set to “25” at the time of factory shipping.
※
The setting in the last session, if any, will be displayed.
(3) Use the UP key and the DOWN key to set a temperature.
Each press of the UP key increases the set temperature by 1
℃
and
each press of the DOWN key decreases it by 1
℃
.
(Keeping them pressed will continually increase or decrease the
value.)
※
When any key operations are made for 10 seconds or more in
the setting input mode, the set temperature indicated at that
time will be input and the mode will switch to the measurement
mode.
(4) Pressing the SET key switches to the measurement mode and the
temperature setting is completed. The display will show the current
liquid temperature.
(Temperature indication on)
(5) Pressing the RUN/STOP keys start temperature control at the set
temperature.
(RUN lamp on)
Lighting
Input of settings
Flash
OFF state ON state
Flash