- 10 -
※
About the handle
Although it is designed to be highly endurable, it might
deteriorate or break depending on the use environment.
※
Water entering inside the unit may cause an electric leak or
an electric shock.
Be sure to remove the power cord before starting draining
or cleaning.
(6) When the liquid temperature in the bath has been
stable, press the power key of the evaporator to turn it
to ON, lower the jack slowly to soak the specimen
flask in the liquid.
Take extreme care not to make the liquid spill over.
When the amount of liquid is insufficient, replenish
liquid little by little taking care liquid will not spill
over the flask.
※
Although the product has been designed so that
any spilled water from the bath will not enter
inside, if water should enter in the unit, an electric
leakage or an electric shock may result.
If a spill should occur, first wipe off any moisture
off the bath body, allow it to completely dry at a
well-ventilated place before attempting to use it
again. (When drying, do not place it upside down
or on its side.)
(7) Rotate the specimen flask to start condensation.
※
Raise the rotation speed only slowly to avoid the
water from spilling over or ruffling.
※
Take care not to burn yourself since hot water
may ruffle while the flask is rotating.
※
Do not put the cover on the bath.
The cover may burn from the heater heat. And
overheating may cause inside the bath hot and a
malfunction may result.
(8) To finish operating, stop the evaporator rotation, raise
the jack, release vacuum, press the RUN/STOP key to
stop temperature control and then turn all power OFF.
FREE
LOCK
Handle
Procedures after operation
※
Be sure to press the RUN/STOP key to stop
temperature control before turning the power
switch OFF.
This product has an automatic recovery function
(power outage recovery function).
Turning the power switch OFF in the RUN state
will turn the heater on at the same time as power
and an accident may result.
Specimen flask
Jack
Power key
RUN/STOP key
Rotation adjusting knob
If you are not going to use the product for a long time, turn the
power switch OFF and remove the power cord out of the outlet.
Completely drain the bath and carefully wipe any moisture with
a dry cloth.
