Installing Cable Retractors (Optional)
Extron cable retractors retract and neatly store cables in Cable Cubby systems, preventing them
from tangling underneath the table. Retractor kits are available for many cable types. They are
not provided with the touchpanel and must be purchased separately.
Up to two retractors can be installed in each 525C module in the TLP Pro 525C. The
TLP Pro 525C can also accommodate the Retractor double bracket (up to two retractors) or a
Retractor triple bracket (up to three retractors).
Up to six retractors can be installed in the TLP Pro 725C enclosure (three on each end in a
Retractor triple bracket).
figure 21
e
21-
525
-01
LF
21-
526
-01L
F
Insert Retractors into
the Retractor bracket.
Slide the bracket
into the enclosure
as shown
(either side).
1
3
4
Secure the bracket
with the included
screws and washers.
2
Secure the Retractors
with the included
mounting pin and clip
Secure the locking screw
on each Retractor. Do not
overtighten.
5
Figure 21.
Installing Cable Retractors
Extron recommends mounting
an empty Retractor bracket into
the touchpanel and installing the
retractors after the enclosure is
seated in the table.
1.
Slide the Retractor bracket
into the enclosure (see
figure 21,
1
).
2.
Secure the bracket to the
enclosure with the provided
#6-32 pan-head screws and
star washers (
2
).
3.
Mount the enclosure into the
table (see
previous page).
4.
From under the table, insert the
Retractors into the bracket (
3
)
and secure them with the clevis
pin and cotter pin (
4
).
5.
Secure the locking screw on
each Retractor (
5
).
To mount the retractors horizontally
and for further information and
installation instructions, see the
Retractors User Guide
, which is
available at
The guide also provides information
about mounting the XL retractors
at a 30° angle to satisfy ADA
compliance requirements.
TLP Pro 525C and 725C Series Touchpanels • Mounting
25
