Extron electronics DVS 605, Руководство пользователя, Страница: 114 / 133

Input Presets
A total of 128 global input presets are available for the DVS 605. An input preset is a
user-defined set of input and picture control settings that can be saved for each source
within a system so that they can be recalled whenever the source is applied. Input presets
are unique to the signal that was applied when the preset was initially saved. This type
of preset saves specific settings for size, position, contrast, brightness, color and tint (if
applicable), detail, and input configuration (see
figure 79 on page 104,
4
).
NOTE:
An input preset can be recalled on any input supporting the input type that
was active when the preset was saved. However, input presets only apply to the
input resolution that was present when the preset was saved.
To create and save an input preset:
1. Adjust the signal sampling, picture control, and size settings (see Size and position
on page 108 .
2. From the Preset Number drop-down menu select a preset number.
3. In the Preset Name field, enter a name for the preset (see Preset Management
Page on page 112 for information about renaming input presets).
4. Click Save . If an input preset already exists in this location, a confirmation dialog box
opens. In the dialog box, click Yes to overwrite the previous input preset.
The settings are saved to the selected preset location to be recalled at a later time
(see
Preset Management Page for the procedure to delete an input preset).
To recall an input preset:
1. From the Preset Number drop-down menu, select the preset to recall.
2. Click Recall . A confirmation dialog box opens.
NOTE: If an unassigned preset is selected, the Recall button is disabled.
3. In the dialog box, click Yes .
NOTE: Recalling a preset overwrites any adjustments to the settings of the current
input. An input preset can also be recalled through the
Preset Management
page.
Overscan
This mode zooms and crops SMPTE inputs to mask edge effects and ancillary data
common in broadcast signals. Issuing an Auto-Image with overscan enabled, runs an
Auto Phase routine (YUV and RGB only) and centers and sizes the input according to
table values.
NOTE:
Overscan is applied only to SMPTE input rates (NTSC, PAL, 480p, 576p,
720p, 1080i, or 1080p).
To set the overscan, select a percentage (0.0%, 2.5%, or 5.0%) from the drop-down
menu that is associated with the desired input signal type (
5
).
DVS 605 • Using the Default Web Pages 106