Extricom EXSW800, Руководство пользователя

Страница: 16 / 58

10 Installing the Extricom WLAN System
Determining the Location of the Extricom Access
Points
Before installing the switch and Access Points, plan the placement of the APs. Before permanently
mounting the APs, it is recommended to test the network (using a laptop client) to identify potential
problems such as coverage holes. If such a problem exists, Extricom’s advanced technology enables
you to easily add or relocate the APs without any need for frequency or cell planning.
The APs should be placed in a stable, secure location, such as on top of a closet or bookshelf, or
mounted on a wall.
The switch should be placed near the distribution point of the LAN line. This is usually in the
communication cabinet of your enterprise.
The Extricom EXSW-800 Switch
The Extricom Switch has 10 connectors and 5 LEDs on the front panel (refer to Error! Reference
source not found. ).
Figure 5. Extricom EXSW-800 Switch
Table 1 describes the Extricom EXSW-800 switches connectors.
Table 1. Extricom EXSW-800 Switch Connectors
Connect
ors Description
Console Serial connector – only to be used by, or as instructed by Extricom
personnel for troubleshooting, support, or maintenance.
LAN RJ-45 connectors – used to connect the switch to the wired LANs. These
connectors provide redundancy and load sharing between them.
LAN2 is currently not functioning.
WLAN RJ-45 connectors – used to connect Extricom Access Points to the switch.
-
Do not connect any device other than Extricom APs to
the WLAN ports.
These ports provide 802.3AF PoE compatible power.
Maximum current: 270 mA, 48 volts.