EVS Multicam LSM, Руководство по эксплуатации

Страница: 220 / 242

Managing Cue Points
When the controller controls the camera, press Mark to define and set up to 255 cue
points. You can add the cue points on the current block in record mode.
When the Cues parameter is set to On , you can press the Last Cue key to call back the
cue points. As cue points are managed by block, select first the requested block to be
able to recall the cue points defined in this block.
Refer to the following topics for more information on cue point management:
• "LCD Menu on the Remote Panel" on page 205
• "Key Commands on the Remote Panel" on page 202
• Specific features of each camera model for more information on cue point
management.
Managing Memory Blocks
Defining the Number of Memory Blocks
Some cameras allow the users to split the memory into several blocks of the same size.
Before recording material on the hypermotion camera, you should specify how many
memory blocks you are going to use (1, 2, 3, or 4 blocks). By default, only one memory
block is defined.
Note
When using more than one memory block, the blocks are considered as
independent units. That means that you have to manually shift from one block to
the other to continue recording on the next block.
To define the number of memory blocks on a hypermotion camera, proceed as follows:
1. In the hypermotion menu, press MENU to open the secondary menu.
2. Press A to activate the # Blocks field. This field specifies into how many memory
blocks the camera memory will be split.
3. Jog to select the number of blocks (1 to 4).
4. Press MENU again to validate your choice and come back to the hypermotion main
menu.
The camera memory is now split into the requested number of blocks, all with the same
size. The
A to D CAM keys now correspond to the 1 to 4 memory blocks respectively.
208 9. Advanced Control Modes
EVS Broadcast Equipment SA Issue 12.05.A - May 2014