Eurotherm 216, Руководство пользователя

Страница: 27 / 40

21
GB GB GB GB GB
5 . 1 2 5 . 1 2
5 . 1 2 5 . 1 2 5 . 1 2
INDICATORS INDICATORS
INDICATORS INDICATORS INDICATORS
SMT Flashes when the first part of the SMART
algorithm is active.
Lit when the second part of the SMART
algorithm is active.
OUT1 Lit up when out 1 is ON.
OUT2 A) When used as event or cooling output it
lit up when out 2 is ON.
B) When used as alarm indication:
B.1) Lit if only Alarm1 is in alarm
condition.
B.2) Flashing at slow rate (0.5 Hz) if only
Alarm 2 is in alarm condition.
B.3) Flashing at fast rate ( 2 Hz) if both
alarms are in alarm condition.
°C Lit up if the temperature is displayed in °C.
°F Lit up if the temperature is displayed in °F.
SP (0216 only) Lit when the display shows the
operative set point.
In addition In addition In addition In addition In addition:
a)
The decimal point on the right hand of the
LSD of the upper display, for 0316, or of
the display, for 0216, flashes when the
instrument is working with SP2.
b) The decimal point on the left hand of the
LSD of the lower display, for 0316, or of the
display, for 0216, flashes when the display
shows the time count down.
5.13 OPERATIVE PARAMETERS 5.13 OPERATIVE PARAMETERS
5.13 OPERATIVE PARAMETERS 5.13 OPERATIVE PARAMETERS 5.13 OPERATIVE PARAMETERS
The following is a list of all the available control
parameters.
Note that some parameters may not be displayed
depending on the specific instrument
configuration.
To modify the setting of a parameter proceed as
follows:
1) By means of the pushbutton select the
parameter to be modified.
2) Using the and keys set the value
required.
3) Press the pushbutton to save the new
value and go to the next parameter.
4) Press to return to the previous parameter
without saving.
NOTES NOTES NOTES NOTES NOTES:
1) If, during parameter modification, no
pushbutton is pressed for more than 10
seconds, the instrument automatically reverts
to the “normal display mode” and the new
setting of the last parameter will be lost.
2) The instrument does not display all the
possible parameters, but only those which are
in agreement with:
a) The instrument configuration (see section
4).
b) The setting of parameter P14 (see section
4).
c) The setting of the proportional band (see
section 5.5).
02-0316-1-DER.pmd 22/04/2004, 16.19 21