Chapter 2 Installations
P/I-P3BVL User's Manual 17
100MHz
Host Clock
CPU
100MHz x 7
700MHz
JP3 JP4 JP5 JP6
100MHz
Host Clock
CPU
100MHz x 8
800MHz
JP3 JP4 JP5 JP6
NOTE:
1. Jumper JP2 is used to select the CPU and SDRAM bus speed. It
can be 66MHz or 100MHz. Jumper JP3 to JP6 is for CPU core
frequency ratio selection.
2. Most Intel Pentium III have fixed CPU core frequency ratio.
You don't really need to set up the JP3~JP6 for the CPU already
fused the core frequency.
3. Overclocking your processor and SDRAM module is not
recommended. There is no guarantee for any over-speed
operation.
JP8: ATX POWER
This 2-pin Jumper is to inform the SBC what kind of power supply is
being used for the system. The option can be ATX power or PS2/AT
power.
JP8
Setting
Function
Open/OFF
Use ATX Power
(when Cable connectted)
Short/ON
Use PS2/AT Power
Supply
(Default)
Содержание P/I-P3BVL
