ETOP P/I-P3BVL, Руководство пользователя

Страница: 18 / 68

Chapter 2 Installations
12 P/I-P3BVL User's Manual
CPU Installation
The P/I-P3BVL Industrial SBC Card provides a 370-pins ZIF socket
for Celeron and Pentium II/III-processors with PPGA (Plastic Pin
Grid Array) package.
Before installing the processor into the Socket, ensure that the CPU
fan is installed first. Without a fan circulating air on the CPU, the
CPU can overheat and cause damage to both CPU and SBC card.
To Install a CPU, first turn off your system and remove its cover.
Locate the ZIP socket and open it by first pulling the lever sideways
away from the socket then upwards to a 90-degree right angle.
Insert the CPU with the correct orientation. Use the notched corner of
the CPU with the white dot as your guide. The white dot should point
towards the end of the lever. Notice that there is a blank area where
one hole is missing from that corner of the square array of pin holds.
Because the CPU has a corner pin for three of the four corners, the
CPU will only fit in one orientation. With the added weight of the
CPU fan, no force is required to insert the CPU. Once completely
inserted, hold down on the fan and close the socket lever.
To disassembly the processor, simply pull the lever sideways away
from the socket then upward to a 90-degree right angle. You can take
the CPU out from the socket without help of any tool.
WARNING!:
If no FAN circulating Air on the CPU, the processor
might been overheated and damage both CPU and SBC components.
IMPORTANT:
You must set jumpers for "CPU to BUS Frequency
Ratio" and jumper for "CPU FSB speed" depending on the CPU that
you install.