ETAS
Getting Started
ES430.1 - User’s Guide
52
6.2.6.1
Rules on Connecting the Modules on the DIN Rails using the
ES4xx Angle Bracket (right)
To be able to fasten the modules in the desired arrangement with the ES4xx
angle bracket (right) on DIN rails, observe the following rules:
6.2.6.2
Preparing the Component
6.2.6.3
Connecting the Module with the ES4xx Angle Bracket (right)
To connect the ES400 module with the ES4xx angle bracket (right) requires two
M3 screws, two washers and a screwdriver.
Connecting the module and the ES4xx Angle Bracket (right):
1. Position the module to the left of the ES4xx angle bracket
(right).
2. Align the thread bores of the integrated assembly elements on
the right side of the module with the through bores of the
ES4xx angle bracket (right).
3. Insert one screw through the bore of the ES4xx angle bracket
(right).
4. Fasten the screw with the module from the right side of the
ES4xx angle bracket.
Both parts are now mechanically connected on one side.
5. Insert the other screw through the other bore of the ES4xx
angle bracket (right).
TIP
The two integrated thread bores in the module for accepting the screws can
be accessed only from the right side of the module.
For this reason, the ES4xx angle bracket (right) must always be screwed onto
the module from the right side.
If the module is screwed onto the ES4xx angle bracket (right), no additional
modules can any longer be screwed onto this module.
TIP
The pin of the integrated assembly element can be screwed out of the mod
-
ule by approximately 6 mm.
TIP
Screw the two parts together without canting the threads!
