ETAS ES430.1, Руководство пользователя

Страница: 50 / 122

ETAS Getting Started
ES430.1 - User’s Guide 50
6.2.5.1 Rules on Attaching the Modules to Other Components
Observe the following rules when connecting the modules as required to other
components:
6.2.5.2 Preparing the Component
To drill the openings in the component:
1. Drill two holes in the selected component.
6.2.5.3 Connecting the Module to the Component
To connect the ES400 module to the component, you need two screws M3 and
a screwdriver.
To connect the module and the component:
1. Position the module to the right of the other component.
2. Align the threaded drill holes of the integrated assembly ele
-
ments on the right-hand side of the module to the openings in
the component.
3. Insert one screw into a hole in the component.
4. Screw the screw from the right-hand side of the component
into the module.
Both parts are now connected mechanically on one side.
5. Insert the other screw into the other hole in the component.
TIP
The two integrated threaded holes in the module are only accessible from the
right-hand side of the module.
You therefore have to screw the other component onto the module from the
right.
Once the module is screwed to the other component, you cannot screw any
further modules to this one.
TIP
The pivot of the integrated assembly element can be screwed around 6 mm
out of the module.
TIP
Use the drilling template to prepare the component (see
Fig. 6
- 13 on page 55).
TIP
Screw the two parts together without getting them off-
thread!