ESS InLine 20-Ten Series, Инструкция по установке и эксплуатации

Страница: 11 / 33

IPS Belt Cleaner 11 19/11/2021
Position the mount / tensioner assembly over the marked hole centres, ensuring that
the hole centres are located approximately in the middle of the slots in the mount
bracket. Verify that the mounts fit, and that adequate room is available to tension the
cleaner.
Once mounting position is confirmed, proceed.
Step 3.
At the selected mounting positions, cut the cleaner access slots, and drill the
mount holes in each side of the chute. Dress and de-burr the holes and cut-
outs. Repair the paintwork to prevent corrosion.
Step 4. Fit the Operator Side mount bracket to the chute wall. Position the mount so that
the drilled holes in the chute wall are approximately centred in the slots of the
mount. Bolt the mount to the chute wall using 4 x M12 bolts.
Repeat for the Far Side mount bracket.
Step 5.
Fit the cleaner Mainframe to the mounts.
Note: The mainframe has a mechanical stop at one end (bolt and nyloc nut).
This is the end that fits to the far side mount. Orientate so mechanical stop is
on the underside of the mainframe.
Fix the mainframe using a securing pin and the mainframe saddle to the far
side mount. Select an appropriate hole where the mainframe sits on the
operator side mount.
Step 6. Slide the Blade Cartridge onto the mainframe from the Operator Side. If not
already done, fit the cleaning blades to the cartridge. If using metal cleaning
blades (ABR or Tungsten Carbide), a Urethane End Blade must be installed at
each end of the blade set. End Blades support the belt and prevent scoring of
the belt by the outer edge of the metal blade.
Step 7.
Secure cartridge and mainframe on operator side using a retaining pin in
operator side mount, secure mainframe spacer on far side mount with
fasteners
Note: The mainframe in most cases will have excess length. If required, this
excess can be trimmed from the Far Side end.
Step 8.
Centre the blades to the belt by loosening and re-positioning the blade locks.
Fit the blade cartridge retaining pin.
Note: If the cartridge is too long and cannot be installed without hitting the
opposite end structure, contact ESS for instruction.