ESS InLine 20-Ten Series, Инструкция по установке и эксплуатации

Страница: 23 / 33

IPS Belt Cleaner 23 19/11/2021
SECTION 10 - TROUBLE SHOOTING THE INLINE CLEANER
PROBLEM - Blades vibrate.
CAUSE SOLUTION
Incorrect installation angle Check installation, ensuring cleaner mount is
perpendicular to belt
Belt deflected upward on tensioning of
cleaner Install an idler roller over the belt near the belt
contact point
Belt vibration being transferred to
cleaner Install an idler roller over the belt near the blade
contact point
PROBLEM - Mainframe bent.
CAUSE SOLUTION
Mainframe undersized Stiffened mainframe required. Contact ESS for
assistance
Excessive tension Relax blade tension to maximum tension
recommended in installation instructions
Material build-up between blades,
mainframe and belt
Increase frequency of inspection and service to
once a week
Normal deflection A small amount of deflection is considered
normal. Contact
ESS if excessive deflection
occurs
PROBLEM - Higher blade wear rate than estimated.
CAUSE SOLUTION
Cleaner over-tensioned Tension cleaner enough to clean the belt only
Incorrect blade material Contact ESS for re-appraisal
PROBLEM - Insufficient cleaning - too much carryback.
CAUSE SOLUTION
Cleaner under-tensioned Re-tension cleaner
Build-up on blade Remove blades and clean. Increase service
frequency
Primary Cleaner not functioning correctly Service the Primary Cleaner
Blade vibration
See start of this section
Cleaner overloaded Add additional cleaner