ESS InLine 20-Ten Series, Инструкция по установке и эксплуатации

Страница: 5 / 33

IPS Belt Cleaner 5 19/11/2021
SECTION 1
– SAFETY
The conveyor belt drive and any associated equipment must
be shut down and locked out according to plant safety
procedures before attempting work requiring access to or
opening of the chute or conveyor enclosure. Contact with a
moving conveyor belt and its drive components can result in serious injury or death.
All equipment installed on or around a conveyor belt, including access doors and cut-
outs, must comply with AS 4024.3610:2015 Conveyors
– General Requirements.
Ensure that only suitably qualified and trained personnel install and service this
product, and that all site and statutory safety procedures are followed.
The
IPS Belt Cleaner is designed to be quickly and easily serviced from outside of the
conveyor enclosure. When correctly installed, there should be no reason to reach into the
chute or enclosure to inspect, adjust or change blades on the cleaner. Where site rules permit,
the cleaner can be safely serviced with the conveyor operating.
Where site rules do not permit servicing on an operating conveyor, ensure that the conveyor
is shut down and locked out before carrying out any service work. The conveyor must be shut
down and locked out during installation of this cleaner.
The following hazards may be present when installing this equipment:
Hazard Hazard
X Moving Conveyor - ISOLATE Other:
Hot Work Other:
Working at Heights Other:
Heavy Lift Other:
Persons Working Overhead Other:
Persons Working Below Other:
Electrical & Cabling Other:
X Pinch Points Other:
Trip Hazards
Confined Space Entry
Once hazards have been identified, the installer should undertake and document a
comprehensive Job Hazard Analysis according to site requirements and good safe-working
practice.
The installer must identify all hazards and apply appropriate controls before proceeding with
the installation or servicing of this equipment.