ESS InLine 20-Ten Series, Инструкция по установке и эксплуатации

Страница: 12 / 33

IPS Belt Cleaner 12 19/11/2021
Step 9.
With the cleaner tensioner in the fully retracted position, the cleaning blades
should be approximately 15-20mm clear of the underside of the belt for Air
Tensioned models and 5-10mm clear for Spring Tensioned models. This
distance should be equal across the width of the belt.
If necessary loosen the bolts and adjust the mounts up or down in the slots to
achieve this clearance. Once all clearances are correct, thoroughly check all
mounting and locking screws to ensure they are tight, and the cleaner is
secured.
Step 10. For the Air Tensioned model only, connect the air tube to the fittings in the Far
Side airbag, on the underside of the mount bracket. See figure 6, section 6.
Pass the tube through the mainframe to the Operator End. Connect the tube to
the Tee air fitting in the Operator Side airbag, adjusting the tube length to suit
by cutting.
Connect the other side of the Tee fitting to the incoming regulated compressed
air supply from the
ESS Air Tensioner Control Box. Connect the plant air
supply to the inlet side of the Control Box. Refer to the installation manual for
the
ESS Control Box for further set-up instructions.
Installation is now complete, and the cleaner is ready to be adjusted
against the belt.