13
MAINTENANCE
Caution:
Before performing any maintenance, follow the safety information in
the ETS-Lindgren
Product Information Bulletin
included with your shipment.
Caution:
Do not perform maintenance while the MAPS is operating. During
maintenance, disconnect power for safety.
Warning:
Only qualified individuals should conduct maintenance inspections
or perform maintenance on the MAPS.
If you have any questions concerning maintenance,
contact ETS-Lindgren Customer Service.
Belt Tension
Proper belt tension is required for the equipment to function correctly. See
Using the Tension Scale to Measure and
Set Belt Tension,
page 26, for the steps to measure and set the tension on the belt.
WARRANTY
Routine Maintenance
Perform the following maintenance prior to each use:
• Visually inspect the Multi Axis Positioning System (MAPS™) and surrounding absorber.
• Attempt to rotate each axis by hand. Excessive rotation may indicate a loose drive component.
• Check the belt tension and make any necessary adjustments.
During operation, listen for excessive or unusual noise.
Bi-Annual Maintenance
Perform bi-annual maintenance every six months after the MAPS is placed into operation. Prior to maintenance,
remove sufficient amounts of absorber to provide access to the casters.
Grease the turntable casters every six months or after every 2000 hours of operation. Use a good quality bearing
grease and a standard SAE grease gun to lubricate the casters.
Annual Maintenance
Perform the following maintenance every 12 months after the MAPS is placed into service:
• Use a good quality bearing grease to lubricate the turntable main bearing race. The grease fittings are located
inside the race, 90° apart, under the top. Three discharges from the grease gun in each fitting are adequate.
• Use a good quality grease to lubricate the chain and sprocket of the chain drive.
Содержание ETS-LINDGREN MAPS 2112 Series
