Escea AF series, Инструкция по установке и обслуживанию, Страница: 15 / 58

B
A
C
D
E
F
G
SER
VICE
15
Rigid flue system rules for installation:
• The appliance comes with 300mm of flexi flue (compressed) and a converter box to convert the
appliance to rigid flueing.
• Any offsets in your flue configuration should be 45° where possible.
• If your flue configuration has a horizontal run, there must be a minimum 1° inclination (20mm
vertical rise per 1m horizontal run) leading upwards towards the termination.
• Do not install the flue with horizontal sections sloping down towards the termination. This could
cause the fire to operate incorrectly and possibly create an unsafe condition.
• This flue system cannot be cut to length. Correct lengths must be selected for each installation.
For a full list of available flue lengths, contact your Escea retailer.
• The listed length of the flue pipe is not the installed length. 1 ½” (38mm) needs to be subtracted
for each join to determine the installed length of each piece of flue pipe.
E.g. 48” length has installed length of 45”.
•
All vertical measurements should be measured from the top surface of the fireplace casing itself
(not the fascia).
• When using 90° elbows in the installation, use the diagram below to help calculate installations
horizontal and vertical distances. 1½” (38mm) will still need to be subtracted from each join.
• When using horizontal flue runs, vertical measurements should be measured to the centre line of
the horizontal flue pipes (as shown in diagram below).
• If using a 45° offset in your installation, consult the chart below to select the required flue length
to give the desired offset. 1½” (38mm) will still need to be subtracted from each of the 45° bends
to allow for the joins.