ESAB ESP-200, Инструкция по эксплуатации

Страница: 13 / 102

13
seCtIon 3 InstallatIon
FaIlure to FolloW InstruCtIons CoulD leaD to Death, InJurY
or DaMageD propertY. FolloW these InstruCtIons to pre-
Vent InJurY or propertY DaMage. You Must CoMplY WIth lo-
Cal, state anD natIonal eleCtrICal anD saFetY CoDes.
WarnIng
use lifting eye When hoisting From overhead.
use safe practices when transporting with overhead method.
unit weighs over 700 lbs. use approved straps or cables in good
condition.
CautIon
3.1 general
3.2 unpacking
Inspect for transit damage immediately upon receipt. •
Remove all components from shipping container and check for loose parts in container. •
Inspect louvers for air obstructions. •
Do not restrict air Flow
restricting intake air with any type of filter on or around the plasma
console will result in overheating and may void the warranty.
CautIon
3.3 placement
A minimum of 2 ft. clearance for cooling air flow. •
Plan for top panel and side panels having to be removed for maintenance, cleaning and inspection. •
Locate the ESP-200 relatively close to a properly fused electrical power supply. •
Keep area beneath power source clear for cooling air flow. •
Environment should be relatively free of dust, fumes and excessive heat. These factors will affect cool- •
ing efficiency.
Conductive Dust and Dirt Inside power source May Cause arc Flash-
over.
equipment damage may occur. electrical shorting may occur if dust
is allowed to build-up inside power source. see maintenance sec-
tion.
CautIon