Ericsson ECN330, Руководство пользователя

Страница: 621 / 1226

Command Line Interface
615
1553-KDU 137 365 Uen D 2006-06-16
7.6.6 snmp-server host
This command specifies the recipient of SNMP traps and notifications. Use the
no
form to remove the specified host.
Syntax
snmp-server host < host-addr > [inform [retry < retries> |
timeout <
seconds>
]]
<community-string>
[version {1
| 2c | 3 {auth | noauth | priv} [udp-port < port> ]}
no snmp-server host < host-addr >
•
host-addr
- Internet address of the host (the targeted recipient).
(Maximum host addresses: 5 trap destination IP address entries)
• inform - Notifications are sent as inform messages. Note that this
option is only available for version 2c and 3 hosts. (Default: traps are
used)
•
retries
- The maximum number of times to resend an inform
message if the recipient does not acknowledge receipt. (Range:
0-255; Default: 3)
•
seconds
- The number of seconds to wait for an
acknowledgment before resending an inform message.
(Range: 0-2147483647 centiseconds; Default: 1500
centiseconds)
•
community-string
- A password-like community string sent with
the notification operation to SNMP v1 and v2c hosts. Although this
string can be set using the
snmp-server host
command by itself,
it is recommended that the string be defined using the
snmp-
server community
command prior to using the
snmp-server
host
command. (Maximum length: 32 characters)
•
version
- Specifies whether to send notifications as SNMP v1,
v2c, or v3 traps. (Range: 1, 2c, 3; Default: 1)
•
auth | noauth | priv
- This group uses SNMPv3 with
authentication, no authentication, or with authentication and
privacy.
•
port
- Host UDP port to use. (Range: 1-65535; Default: 162)