Ericsson ECN330, Руководство пользователя

Страница: 427 / 1226

Configuring the ECN330-switch
421
1553-KDU 137 365 Uen D 2006-06-16
Web - Click IP, Statistics, TCP.
Figure 184 TCP Statistics
CLI - See the example on page 412.
6.20.7 Configuring Static Routes
This router can dynamically configure routes to other network segments using
dynamic routing protocols (that is, RIP or OSPF). However, static routes can
also be manually entered in the routing table. Static routes may be required to
access network segments where dynamic routing is not supported, or can be set
to force the use of a specific route to a subnet, rather than using dynamic routing.
Static routes do not automatically change in response to changes in network
topology, so only configure a small number of stable routes to ensure network
accessibility.
Command Attributes
• Interface – Index number of the IP interface.
• IP Address – IP address of the destination network, subnetwork, or
host.
• Netmask – Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
• Gateway – IP address of the gateway used for this route.
• Metric – Cost for this interface. This cost is only used if a route is
imported by a dynamic routing protocol such as OSPF. (Range: 1-5,
default: 1)
• Entry Count – The number of table entries.