Equitrac PageCounter, Руководство по обслуживанию на месте

Страница: 28 / 126

Installation and Initial Configuration:
Accessing Manager Mode Upon Initial Startup
2 - 6
Accessing Manager Mode
You can access Manager Mode when the terminal initially starts
up. When the terminal is configured for Mode 1 communication,
you can also access Manager Mode when the terminal is Idle.
Upon Initial Startup
If the terminal has not yet been connected to a power source, complete the following steps
to access Manager Mode:
1
Connect power to the PageCounter.
2 Press the
F2
function key when the terminal screen displays the message Loading
Firmware .
3
Enter a password and press
ENTER
.
The password appears as asterisks on the display. Use the function keys or the
BACK
key
to exit the password, if needed.
Note: When the terminal is configured for Mode 1 communication, the Bypass key must be
set to on and the default Manager Mode password is Q. The default password can be
changed by the System administrator using Manager Mode. The permanent
password (for Equitrac Service Technicians only) is EQU.
To enter alphabetic characters on a terminal without a keyboard, press the
HOLD
key
to display an alphabet on the display screen. Use the function keys to move the
cursor to the desired character and press
ENTER
. Press the
HOLD
key again to return to
the entry screen.
If the terminal is not equipped with the optional QWERTY keyboard, or if the terminal
is configured for Mode 2 communication, the default Manager Mode password is
2468.
From Idle Mode (Mode 1 only)
You can access Manager mode when the terminal is sitting in Idle mode and configured for
Mode 1 communication. To access Manager mode, perform the following steps:
1 Turn the Bypass key to the ON position.
2
Press the
F2
function key and the
END
key simultaneously.
3 Enter a password. See Accessing Manager Mode on page 2 - 6 for password details.
Press
ENTER
. The Manager Mode menu appears on the screen.
At a Glance...
Upon Initial Startup
From Idle Mode (Mode 1
only)