Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: [email protected] Website: www.integrated-circuit.com
ISPnano Series Programmer - User Manual – V1.11 – 12
th
May 2011
15
1.8 ISPnano Series I - Rear panel connections
The illustration below details the function of each of the connectors on the rear panel of the
programmer.
#
Connector Name
Description / comment
1
DC Power Input
DC Power Input to power the programmer
•
Voltage range: 9.0 – 24.0 V DC (right-hand pin positive)
2
EXTERNAL TARGET VCC
INPUT
EXTERNAL TARGET VCC INPUT
•
DC Power Input to power the programmer
•
Voltage range: 3.0 – 24.0 V DC (right-hand pin positive)
3
Programmer STATUS LEDs Programmer ‘Status’ LEDs
•
From Left to right:
•
PASS (GREEN)
•
BUSY (YELLOW)
•
FAIL (RED)
4
RS485 Ports
RS485 Ports (1) + (2) - Serial Communications Ports
•
These port can be used to control the programmer via an
RS485 link from a PC. They are connected in parallel internally
so it does not matter which is used as the RS485 INPUT or
OUTPUT.
•
The connector is a 5-pin 2.54mm Molex.
5
RS232 Port (1)
RS232 Port (1) - Serial Communications Port
•
This port can be used to control the programmer via an RS232
link from a PC or other Test Equipment.
•
The connector is a 3-pin 2.5mm Molex.
6
RS232 Port (2)
or Remote Display Keypad
RS232 Port (2) - Serial Communications Port
•
This port can be used to control the programmer via an RS232
link from a PC or other Test Equipment.
•
A
‘Remote Display / Keypad Module’
can also be connected
to this port allowing the programmer to be remote controlled.
•
The connector is a 4-pin RJ11 connector.
2
1
3
4
5
6
32 / 135
32 / 135
