Epson Stylus Color 880, Руководство по обслуживанию

Страница: 22 / 179

EPSON Stylus COLOR 880 Revision A
PRODUCT DESCRIPTION OPERATOR CONTROLS 22
1.4.3 Panel Functions
* It is described in the user’s manual that three seconds are
required.
**This function is not available in printing status.
*1: One of the following actions is carried out according to the content of
1BH of EEPROM
.
*2: Not described in the user’s manual.
*3: See the table below.
Table 1-9. Panel Functions
Switch Function
Load / Eject
(Push for less than
2 sec.*)
• Loads or ejects a paper.
• When the carriage is on the ink cartridge replacement
position, return the carriage to the capping position.
Load / Eject
(Push for 2 sec.*)
• Starts the ink cartridge replacement sequence.**
• Moves the carriage to the cartridge replacement position.
Cleaning
(Push for 2 sec.*)
• Starts cleaning of the printhead.
• In the condition of “Ink Low”, “Ink Out”, or “No Ink Cartridge”,
starts the ink cartridge replacement sequence.**
Cleaning
(Push for less than
2 sec.*)
• When the carriage is on the ink cartridge replacement
position, return the carriage to the capping position.
Table 1-10. Panel Function with Power On
Switch Pressing with Power On Function
Load / Eject
• 1) Starts status printing. *1
Cleaning
• Changes code pages / Select IEEE1284.4 mode for parallel
I/F. *2
Load/Eject
+
Cleaning
• Enters the special settings mode. (Factory use only). *3
Content of 1BH of
EEPROM, [bit7] [bit6]
Action
00
Print firmware version, ink counter, selected
code page and nozzle check pattern.
11
01 Start hex-dump printing.
10 Start self test printing.
Table 1-11. Special Setting Mode
Switch Function
Load / Eject
• Initialize EEPROM and reset timer IC.
Cleaning
(Push for 10 seconds)
• Reset the ink overflow counter in EEPROM.