Epson SCARA GX Series, Руководство пользователя

Страница: 81 / 236

GX4 Manipulator 5. Motion Range
GX series Rev.2 71
(7) Turn ON the Controller.
(8) Move Joint #3 to its lower limit while pressing the brake release switch, and then check
the lower limit position. Do not lower the mechanical stop too far. Otherwise, the
joint may not reach a target position.
(9) Calculate the lower limit pulse value of the pulse range using the formula shown below
and set the value.
The result of the calculation is always negative because the lower limit Z coordinate
value is negative.
GX4-A**1S*(Z:-150 mm):
Lower limit of pulse =(lower limit Z coordinate value)/16
×
131072
×
(50/36)
<Example: When lowering the mechanical stopper by 50 mm and changing the lower
limit Z coordinate value to “-100” with a 150 mm stroke>
( − 100)/16 × 131072 × (50/36) = -1137778
EPSON
RC+
Execute the following command from the [Command Window].
>JRANGE 3,-1137778 ,0
‘Sets the pulse range of Joint #3
(10) Using the Pulse command (Go Pulse command), move Joint #3 to the lower limit
position of the pulse range at low speed. If the mechanical stop range is less than the
pulse range, Joint #3 will hit the mechanical stop and an error will occur. When the
error occurs, either change the pulse range to a lower setting or extend the position of
the mechanical stop within the limit.
If it is difficult to check whether Joint #3 hits a mechanical stop, turn OFF the
Controller and lift the arm top cover to check the condition causing the problem
from the side.
<Example: When lowering the mechanical stopper by 50 mm and changing the lower
limit Z coordinate value to “-100” with a 150 mm stroke>
EPSON
RC+
Execute the following commands from the [Command Window]. Enter the value
calculated in Step (9) in
−
1137778.
>MOTOR ON ' Turns ON the motor
>SPEED 5 ' Sets low speed
>PULSE 0,0,-1137778,0 ' Moves to the lower limit-pulse position of Joint #3.
(In this example, all pulses except those for Joint #3
are “0”. Substitute these “0s” with the other pulse
values specifying a position where there is no
interference even when lowering Joint #3.)

NOTE