Enerzone Cambridge EP00075, Инструкция по установке и эксплуатации

Страница: 12 / 92

12
Cambridge Pellet Stove Installation and Operation Manual
3 CLEARANCES TO COMBUSTIBLE MATERIALS
The clearances shown in this section have been determined by tests according to procedures set out
in safety standards ULC S627 (Canada), ASTM E1509 (U.S.A) and UL1482 (USA). When the pellet stove
is installed so that its surfaces are at, or beyond, the minimum clearances specified, combustible
surfaces will not overheat under normal and even abnormal operating conditions.
WARNING
•
NO PART OF THE STOVE MAY BE LOCATED CLOSER TO COMBUSTIBLES THAN THE MINIMUM
CLEARANCES SPECIFIED ON THE CERTIFICATION LABEL.
•
NO PART OF THE PELLET VENT SYSTEM MAY BE LOCATED CLOSER TO COMBUSTIBLES THAN
THE MINIMUM CLEARANCES SPECIFIED BY THE VENT MANUFACTURER.
CAUTION
•
DO NOT USE MAKESHIFT MATERIALS OR MAKE ANY COMPROMISES WHEN INSTALLING THIS
STOVE.
3.1 Certification Label Location
Since the information given on the certification label affixed to the stove always overrides the
information published in any other media (owner’s manual, catalogues, flyers, magazines and/or web
sites), it is important to refer to it in order to have a safe and compliant installation. In addition, you
will find important information about your stove (model, serial number, etc.). You will find the
certification label on the inner side of the hopper lid of the stove.
3.2 Clearances to combustibles materials, walls and ceiling
The distances listed in this table refer to the distances obtained during regular testing. However, it is
possible to install the stove at reduced clearances by installing either a
certified heat shield system
(AC02710) or a side clearance reduction kit (AC02733), sold separately.
*
From the rear panel
**
Measured from the platform on which the product is
installed.
RECOMMENDED CLEARANCES
2
LETTER CANADA USA
A
*
12 " (305 mm) 12 " (305 mm)
MINIMUM CLEARANCES
LETTER CANADA USA
A
*
3
"
(76 mm) 3
"
(76 mm)
D Note 1 Note 1
I
**
48 " (1 220 mm) 48 " (1 220 mm)