Enerzone Cambridge EP00075, Инструкция по установке и эксплуатации

Страница: 35 / 92

Cambridge Pellet Stove Installation and Operation Manual
35
6.1.9 Selecting the Pilot Cycle
To change the pilot cycle press the word “AUTO” from the Main Status Page. You can choose from
one of the four different pilot cycles: "ALWAYS ON", "30 MINUTES", “60 MINUTES”, or "ALWAYS OFF".
The selected cycle will be displayed under the word “AUTO” on the main status page. Default setting
is "ALWAYS OFF" since this is the most fuel efficient configuration.
Press on AUTO
button to set
pilot time settings
Note: Pilot feed rate is lower than the minimum combustion level feed rate.
6.1.9.1 Always OFF
When the “ALWAYS OFF” pilot cycle is selected, the stove will shut down when the temperature set
on the thermostat is reached. Every time the thermostat will call for heat, the stove will go through
the complete ignition cycle.
6.1.9.2 30 Minutes or 60 Minutes
The pilot cycle begins when temperature set on the thermostat is reached. It will last 30 or 60
minutes depending of the selected pilot cycle. If the thermostat does not call for heat before the end
of the selected pilot cycle delay, the stove will shut down and will need to go through the complete
ignition cycle when the thermostat calls for heat again.
6.1.9.3 Always ON
The pilot cycle begins when temperature set on the thermostat is reached. When the “ALWAYS ON”
pilot cycle is selected, the stove will remain on pilot mode until the thermostat calls for heat.