65 / 81
configuration window is shown. There, we will configure the three following
parameters:
Pulse Width
: time in 1/100 seconds that the DX button state will be ON. Values
go from 0 to 100.
Pause
: time in 1/100 seconds that the DX button state will be OFF after the ON
state. Values go from 0 to 100.
Limit
: maximum time in 1/100 seconds that the sequence will be repeated, as
long as the button is pressed.
If value “0”, it will be repeated until the button is
released. Values go from 0 to 100.
This DX button configuration is independent for every slot, i.e. you can configure a DX
button as a pulse system in a particular slot and as a standard button in another slot.
As you see in the previous images, we
have configured the Direct X button “0” of slot
number “1” to send up to a maximum of two pulses of 0,01s, with a spacing of 0,04s, if
the button is pressed almost 0,1 second (10 x 1/100 seconds). If we release the button
before finishing the sequence, it is cancelled.
Let us see the sequence when we press Trigger 1 (button 0) more than 0,1 second
and the sequence when we release before the time limit:
TRIGGER 1 PRESSED
TRIGGER
1
PRESSED
D
X0
-ON
D
X0
-ON
D
X0
-ON
A
A
A
PU
L
SE
PAUSE
PU
L
SE
PAUSE
PU
L
SE
PA
U
SE
Shifter and Toggle
These two new functions allow to change the active slot to a predefined slot through an
activation of a previously assigned button, without the use of the rotary switch. To do
this, there are two modes:
Shifter
and
Toggle
.
1/100s
Limit
Pulse Width
Pause
