Emerson Rosemount ET310, Быстрый старт

Страница: 22 / 52

NOTICE
When the worm-screws are tightened, the springs in the tensioner
are compressed. To avoid the strap becoming lose or over-tightened
when the pipe temperature changes, it is important that the spring is
set to the correct tension. Do not over-tighten the worm-screws.
7. Ensure the metal plate is centered through the plus (+) shaped cut-
outs on both sides of the tensioner. If it is not centered, either loosen
or tighten the worm-screws on either side until they do align. Ensure
the sensor is firmly fixed and sitting perpendicular to the pipe as
shown in
Figure 3-4 .
8. When all the adjustments have been completed, make a final check
of the waveform quality (refer to Figure 3-3 ).
• If it is poor, slacken off the strap and adjust the sensor position
before returning to
Step 3 .
• If the waveform quality is good, continue to Step 9 .
9. If there is an excessive length of spare strap, you may cut off the
excess length.
10. Click the Complete button.
Verify the Install State is
Off
and Installed is selected in the footer of
the application.
Figure 3-6: Installation Tool Screen: Fully Provisioned
11. Remove the CC21 and fit the power module, tightening the two
power module retaining bolts. Refer to the Rosemount BP20E Power
Module for Wireless Corrosion Transmitter Quick Start Guide .
When the power module is fitted, the sensor automatically restarts
and tries to join the
Wireless HART
®
Gateway. In a large network of
100 sensors this can often take two hours, and sometimes up to six
hours.
Quick Start Guide January 2022
22 Emerson.com/Rosemount