Emerson Rosemount ET310, Быстрый старт

Страница: 43 / 52

A Adjusting the height of the magnetic unit
You may need to adjust the height of the magnetic unit if the magnetic
fixture is mounted on a non-spherical or uneven surface.
Procedure
1. Loosen the top and bottom nut on the ball stud that holds the frame
in position. A 13mm A/F spanner might be required to loosen the
bottom nut while holding the ball stud with an 8mm spanner.
2. Back off the top nut to the end of the thread.
3. Raise the frame to the desired height, so that all 4 magnetic units are
sitting comfortably on the vessel surface.
4. Position the bottom nut at the desired height.
5. Using the 13mm spanner to hold the bottom nut, torque the top nut
to 14Nm.
A. Before adjustment
B. After adjustment
January 2022 Quick Start Guide
Quick Start Guide 43