Emerson FB3000, Инструкция по эксплуатации

Страница: 69 / 96

Emerson FB3000 RTU Instruction Manual
D301851X012
May 2022
Operation 57
Section 4: Operation
This section covers the following topics:
 Powering Up/Powering Down the Device
 Establishing Communications
This section describes day-to-day operation of the RTU including how to turn it on and
off, and how to communicate with it.
4.1 Powering Up/Powering Down the Device
WARNING
Explosion Hazard – Connect or disconnect only in a non-hazardous area.
The power supply modules include terminals that power the RTU and field devices.

Plug in external power connectors on the two power supply modules to power on
the RTU.
 Unplug external power connectors on the two power supply modules to power off
the RTU.
4.2 Establishing Communications
The RTU supports communications through the host SCADA system, or through a local
laptop computer running FBxConnect.
4.2.1 Communicating with the SCADA Host
Communication to the RTU through a SCADA host computer requires configuration of
the host computer software, which varies depending upon whether you are using
OpenEnterprise or another host software package. Much of this configuration is beyond
the scope of this topic, but no matter which host you are using, there are certain steps
you must take:
1. Decide how the SCADA host should communicate with the RTU. This could be
through connection with one of the communication ports. A serial port
connection could be a cable directly connected to the SCADA host or there could
be intermediate connections through a radio or modem. An Ethernet port
connection must be through an Ethernet switch with an appropriate Category 5
shielded patch cable.
2. Decide which communication protocol you will use. This could be DNP3 or
Modbus. See these documents for more information:

DNP3 Protocol Specifications Manual (for Emerson FB3000 RTUs)
(D301858X012)