23
Parameter setting
Ultrasonic Probe KNX SO250
• Version: 14.09.2020 • Technical changes and errors excepted.
Measuring behaviour:
Note: If the measurement is made on request the measured value will be sent imme
-
diately.
Transmission behaviour:
7.2. Tank and calculation (only for fill level
measurement)
7.2.1. Rectangular tank
Perform measuring
cyclically • on request and cyclically
Use object measuring block
If the object is used:
for value: 1 = Block measurement |
0 = release measurement
Value before 1st communication: 0
Yes • No
Measured value
• send cyclically
• send in case of change
• send in case of change and cyclically
from change in %
(only for sending "in case of change")
1 … 50
send cyclically every
(only for "cyclic" sending)
5 sec … 2h
Output of the measured value in
Litre • cubic metres • % • m
Send max. filling amount on request
Yes • No
Send max. filling amount in
(only when filling amount is sent on
request and measured value is displayed in
% or in m)
Litre • cubic metres
General sending delay
after power up and programming
5 sec • 10 sec • 20 sec • 30 sec • 1 min •
2 min • 5 min
Tank design
•
Rectangular
• Spherical tank
• Cylinder vertical
• Cylinder horizontal
Volume indicated in
Litres • Cubic metres
Volume in Litres
Volume in cubic metres
1 … 10.000.000
Fill height in cm
1 … 254
Fill level correction
Yes • No
Содержание 70151
Страница 1: ...KNX SO250 Ultrasonic Probe Item number 70151 EN Installation and Adjustment ...
Страница 2: ......
Страница 6: ...4 Clarification of signs ...