elsner elektronik 70151, Установка и настройка

Страница: 28 / 30

26 Parameter setting
Ultrasonic Probe KNX SO250 • Version: 14.09.2020 • Technical changes and errors excepted.
Switching output:
Blocking:
If „use block of switching output: Yes“ is selected:
Behaviour of switching output
The switching output procedure depends on the value of the parameter „Switching
output sends …“ (see „Switching output“).
Step size
(only for "increase/decrease" with one/two
comm. object(s)) 0,1 • 0,2 • 0,5 • 1 • 2 • 5 • 10 • 20 Liter
0,1 • 0,2 • 0,5 • 1 • 2 • 5 • 10 • 20 m³
1 • 2 • 3 • 4 • 5 • 10 %
1 • 2 • 5 • 10 cm
Hysteresis of the threshold value in % 0 … 50
Switching delay from 0 to 1 none • 1 sec … 2h
Switching delay from 1 to 0 none • 1 sec … 2h
Output is at • TV above = 1 | TV – Hyst. below = 0
• TV above = 0 | TV – Hyst. below = 1
• TV below = 1 | TV + Hyst. above = 0
• TV below = 0 | TV + Hyst. above = 1
Switching output sends • In case of change
• In case of change to 1
• In case of change to 0
• In case of change and cyclically
• In case of change to 1 and cyclically
• In case of change to 0 and cyclically
Send switching output in a cycle of 5 sec … 2 h
Use block of the switching output Yes • No
Evaluation of the blocking object • if value 1: block | if value 0: release
• if value 0: block | if value 1: release
Value of the blocking object
before 1. communication 0 • 1
with blocking do not send telegram • send 0 • send 1
with release (depending on switching output sending
procedure)
Switching output sends in case of change • do not send telegram
• send status of the switching output
Switching output sends in case of change
to 1 • do not send telegram
• wenn Schaltausgang = 1  sende 1